›

MAKE-SHIFT GROUND FOR TURNTABLE

RAJRAJ tenacious local 7,779 Posts
edited October 2005 in Strut Central
anybody got any tips?

  Comments

  • flatblackplasticflatblackplastic 1,209 Posts
    i used an old speaker wire spliced into the og ground wire for a couple of years, got it fixed legitly about 2 years ago for like 15 bucks.
  • dCastillodCastillo 1,963 Posts
    assuming you have a ground wire, and don't know where to put it....

    loosen a screw on your mixer, put the wire in there, and tighten the screw back up.
  • The_Hook_UpThe_Hook_Up 8,182 Posts
    I used a coat hanger once and hooked it into one of the air vents on the reciever, it worked until the bass vibrations rattled it from its precarious connection.
  • asprinasprin 1,765 Posts
    My grounding is all fucked on my TTBL... every so often, it will generate this buzzing sound and in order to fix it, I have to take it out of the screwed connecting and touch it to an RCA jack...
  • p_gunnp_gunn 2,284 Posts
    regular stereo wire/cable?

    bingo.
  • DORDOR Two Ron Toe 9,901 Posts
    What, no one here grounds internally to the turntable?? Some doods use to do that a ton back in the day.

    I would not advise it mind you...
  • knewjakknewjak 1,231 Posts

    loosen a screw on your mixer, put the wire in there, and tighten the screw back up.


    man, Id advise not to loose up just any screw on the mixer.
    Just make sure the screw is attached to the main under housing.


  • schnipperschnipper 528 Posts
    Paper clip chain or wire hanger
  • p_gunnp_gunn 2,284 Posts
    What, no one here grounds internally to the turntable?? Some doods use to do that a ton back in the day.

    I would not advise it mind you...

    had to do that way too often at wack clubs... a little bit of wire on the fly...
Sign In or Register to comment.